Shower screen leaking? Where the water gets out and what to do

Water on the bathroom floor after a shower is one of the most common shower screen complaints. It usually comes down to one of a few causes: worn seals, failed silicone, the way water hits the screen, or the floor itself. Finding out which one is the first step to fixing it.
First, find where the water gets out
Dry the floor outside the shower, then run the shower and watch from outside. Check under the door, along the hinge or pivot side, where the glass meets the wall, and along the base where the screen meets the hob or floor.
Direct the water at one part of the screen at a time for a minute or so. If the floor stays dry until the water hits a particular joint or gap, you have found the leak. If water appears with no spray near the screen at all, it may be coming from a tap, a pipe or the floor, which is a different problem.
Worn door seals and wipers
Shower doors need small gaps around them so they can open and close freely. Seals and wipers along the door edges close off those gaps. Over time they harden, split, shrink or fall out, and water escapes through the gap, most often under the door or along the closing edge.
This matters most on frameless doors, where clear seals between the door, the fixed panel and the wall do the job a frame would otherwise do. Replacement seals need to suit the glass thickness and the size of the gap.
Failed silicone
Silicone seals the joins between the screen and the walls, hob and floor. It breaks down over the years, pulls away from the tiles or grows mould underneath. Black spots that will not clean off are usually mould inside or behind the silicone, which means it has failed and should be cut out and replaced rather than covered over.
Silicone is a finishing seal. The waterproof membrane under the tiles is what protects the structure, and fresh silicone will not fix a membrane that has failed.
Water aimed at the door or the gaps
Where the shower head points makes a big difference. A head aimed at the door, or at the gap on the hinge side, forces water through gaps that would otherwise stay dry. Angling the head towards the back wall, or keeping a hand shower pointed away from the door, often solves the problem on its own.
Walk-in showers have no door, so overspray depends on the length of the panel and the position of the shower head. Our walk-in shower guide covers this in more detail.
The floor and the hob
A shower floor should fall towards the waste so water drains away instead of pooling. If water sits against the base of the screen, or runs out towards the bathroom floor, the falls may not be right, and no seal will fully hold it back.
A hob, the raised tiled step around the shower, gives an extra barrier. Level entry showers rely entirely on good falls and a well placed waste, which is worth planning with your builder or tiler before the screen is chosen.
A door that has dropped or moved
If a door has dropped on its hinges or pivot, or the frame has shifted, the gaps around the door open up unevenly and the seals no longer meet. Signs include a door that rubs or catches, a gap that is wider at the top than the bottom, or a door that has to be lifted to close. Hinges and pivots can sometimes be adjusted, but if the door will not hold its alignment, a new screen is usually the lasting fix.
Blocked tracks and drainage holes
Older framed and sliding screens have a track or base channel with small drainage holes that let water run back into the shower. When soap, hair or grime blocks them, the track fills and overflows onto the bathroom floor. Clearing the track and the holes with a soft brush is often all it takes.
When water gets behind the tiles
Some leaks are not from the screen at all. Swollen or stained skirting and door frames outside the shower, tiles that sound hollow or lift, grout that stays damp, a musty smell, or damp on the other side of the wall all point to the waterproofing or plumbing. These need a licensed waterproofer or plumber. A new screen will not fix them, and they should be repaired before a new screen is fitted.
When a new screen is the answer
If the screen is old, the frame is corroded, the door will not hold its alignment, or the layout has always let water out, a new screen designed for the space is the lasting fix. Semi-frameless screens offer better water retention options than frameless, particularly with an overlapping door and a framed base, because the frame runs around the perimeter of the glass. On a semi-frameless slider, the moving door sits below the sill to help keep water inside the shower.
Read our guide to replacing an old shower screen for what can stay and how replacement works.
Shower screen leak questions
Why does water leak under my shower door?
Usually because the seal or wiper under the door has worn or fallen out, the shower head is aimed at the door, or the floor falls towards the door instead of the waste. Watch from outside with the shower running to see which one it is.
Will new silicone stop my shower screen leaking?
Fresh silicone fixes leaks at joins where the old silicone has failed. It will not fix a worn door seal, poor floor falls or failed waterproofing, and it should never be used to fill the gaps a door needs to open and close.
Is a leaking shower screen a waterproofing problem?
Not usually. Most leaks come from seals, silicone or the shower head position. Swollen skirting, hollow or lifting tiles, or damp on the other side of the wall point to the waterproofing, which needs a licensed waterproofer or plumber.
Which shower screen is best for keeping water in?
Semi-frameless screens offer better water retention options than frameless, particularly with an overlapping door and a framed base. Whichever style you choose, the layout, the door position and the floor falls all play a part.
Keep reading

Replacing an old shower screen: signs, options and what to expect
Cloudy glass, pitted frames or a door that leaks? The signs a screen is due for replacement, what can stay and how a new screen is fitted.
Read the article
How to clean a shower screen and keep it clear
A few simple habits keep a glass shower screen clear for years. What to use, what to avoid, and how to look after the frame, hinges and rollers.
Read the article
Shower glass delamination: what it is and why replacement is best
Cloudy edges or dark marks trapped inside the glass? Learn how delamination happens, why repairs are risky and why full replacement is best.
Read the articleRelated products
Semi-frameless shower screens
A well-designed frame with a pivot door, in eight frame colours.
Semi-frameless sliding screens
A big opening with no door swing, on the Momentum slider system.
Shower screens
Frameless and semi-frameless styles compared side by side.
Time for a screen that keeps water in?
Send photos of your shower and rough sizes, and we will come back with a written quote.
